Graduate Student Dane Miller of the University of Maryland presented at the Vanderbilt Seminar Series.
Radiation effects on spacecraft power electronics pose a critical challenge for affordable missions, where cost constraints often preclude the use of space‑qualified hardware. Developing a modular power architecture that relies on commercial‑off‑the‑shelf (COTS) components can lower barriers to entry while still meeting mission‑level reliability when appropriate hardening strategies are applied. This resource examines the engineering workflow that enables such low‑cost, radiation‑tolerant power systems.
The presentation details a systematic evaluation of shielding materials, beginning with dose‑attenuation measurements performed in the Maryland Beta‑Linac. Polyethylene, bakelite, and polypropylene coupons are exposed to mono‑energetic beams, and attenuation curves are refined using sandwich configurations that incorporate 100 mil 6061‑Al backing to emulate realistic spacecraft geometry. Thermogravimetric analysis (TGA) quantifies mass loss under inert‑gas heating at 90 °C and 150 °C, directly comparing the results to NASA’s 1 % total‑mass‑loss limit for off‑gassing compliance. Gamma total‑ionizing‑dose (TID) testing of gallium‑nitride (GaN) transistors, silicon‑carbide (SiC) Schottky diodes, and gate‑driver assemblies is conducted in a cobalt‑60 irradiator, with curve‑tracer measurements tracking threshold‑voltage shifts and leakage‑current trends across cumulative doses up to 100 krad. Statistical analysis of the collected data informs predictive models for component degradation and shield performance across the particle‑energy spectrum encountered in low‑Earth and geosynchronous orbits.
Armed with this knowledge, learners can articulate why COTS parts are advantageous for low‑cost spacecraft power subsystems and assess the relative radiation‑attenuation effectiveness of polyethylene, bakelite, and composite shields. They gain the ability to interpret TGA results to verify material compliance with NASA off‑gassing standards, to analyze gamma‑TID test data for identifying the most vulnerable device parameters, and to evaluate which shielding configurations satisfy both radiation‑attenuation and off‑gassing requirements, thereby guiding informed design decisions for future space missions.